Firmware Downloads (Standard Wifi Archive)

Release v1.0.5


October 29, 2015

Downloads


Download SkyFire v1.0.5 Firmware
Download SunSpot v1.0.5 Firmware

Change log


New Features:
  • We're changing the way that client connection events are reported so that less data flows between the management agent and the cloud. 
Changes/Fixes:
  • Fixed an issue where a reboot was required to disable bandsteering after applying settings in the UI.
  • In some cases, signal and SNR, on a per-chain bases, were being reported incorrectly. This has been fixed.
  • Some small stability changes were made to the cloud agent. 
  • Adjusted the regulatory settings for the JP country code.

Release v1.0.4


September 8, 2015

Downloads


Download SkyFire v1.0.4 Firmware
Download SunSpot v1.0.4 Firmware

Change log


New Features:
  • Cloud agent: Added the ability to remotely fetch a device's troubleshooting file from the cloud (go to Device dashboard on the cloud, and choose "Fetch Troubleshooting file" from the "Live actions" dropdown.)
  • Add client info output to the troubleshooting file
  • Expose the beacon interval setting on the wireless config pages
  • Expose the DHCP lease time setting on the LANs config page
Fixes:
  • Device UI improvements
  • Client WDS stability improvements
  • Cloud agent stability improvements
  • Fix double counting of WDS interface statistics
  • Fix cloud agent parsing of some 11ac datarates
  • Fix issue where clients aren't always aged out after bandsteering was enabled

Release v1.0.3


June 15, 2015

Downloads

Download SkyFire v1.0.3 Firmware
Download SunSpot v1.0.3 Firmware

Change log


Fixes:
  • Fixed an issue where a device's config may be missing from the cloud when a device with older firmware is registered (such as 1.0.0).
  • Fixed issue where clients show as being associated to an AP even though they aren't (related to bandsteering/minimum signal level settings)
  • Fixed an issue related to DNS resolution on the device (would cause device to incorrectly show up as offline)
  • Updated auto-channel algorithm so that only non-overlapping channels are chosen.

Release v1.0.2

Downloads


Download SkyFire v1.0.2 Firmware (Download not available)
Download SunSpot v1.0.2 Firmware (Download not available)

Change log


New Features:
  • "Troubleshooting file download" option was added to the Maintenance page
Fixes:
  • Fixed issue where in rare cases, clients show as connected to AP but don't pass traffic
  • Fixed issue where clients aren't properly aged out
  • Many small fixes to the cloud agent
  • Many small stability and optimization changes



Release v1.0.1


Downloads


Download SkyFire v1.0.1 Firmware (Download not available)
Download SunSpot v1.0.1 Firmware (Download not available)

Change log


New features:
  • A "Minimum client strength" feature has been added to the wireless configuration pages.  This setting will allow you to reject clients that have a signal strength below a specified threshold.
  • "Bandsteering" support has been added to the wireless configuration page. This setting is only applicable on dual-radio devices.  When enabled, and both radios on your AP have the same SSID, the radio will push 5-GHz enabled clients to the 5 Ghz radio in order to re-distribute the client load across both radios.
  • AP Auto-WDS and Client WDS modes have been enhanced
Fixes:
  • Client mode stability fixes
  • Increased captive portal/hotspot stability
  • Many small stability and optimization changes

Feedback and Knowledge Base