Is there a reset  button on my MetroLinq?

Q: Is there a reset  button on my MetroLinq?


Yes, It is possible to reboot or reset the MetroLinq by inserting a pin in the pin hole labeled “Reset” on the connector panel of MetroLinq and:

◆ press 2 seconds to reboot the MetroLinq;

◆ press 12 seconds to reset the MetroLinq to the factory defaults. The status LED of the radio will change color. Wait approximately five minutes for the unit to be reset to factory defaults.

FAQ - MetroLinq

  1. What is the default login of my MetroLinq?
  2. What is the default IP of my MetroLinq?
  3. Is there a reset  button on my MetroLinq?
  4. Can I reset my MetroLinq to factory defaults from the Web GUI?
  5. How do I download the Troubleshooting Logs?
  6. How do I upgrade my MetroLinq's firmware from the Web GUI?
  7. Does MetroLinq support VLAN?
  8. What is the maximum MTU size for MetroLinq?
  9. Does MetroLinq require Line-Of-Sight (LOS) between devices?
  10. Should I upgrade my MetroLinq's firmware?
  11. Can I reset my MetroLinq to factory defaults from the shell?
  12. How do I save a back-up configuration?
  13. How do I discover the MetroLinq devices in my network?
  14. What are the channel bandwidths supported by the MetroLinq's 60 GHz and 5 GHz radios?
  15. Can my MetroLinq form a PTP link with 60 GHz radios from other brands?
  16. Do MetroLinq devices have a ground point?
  17. Does the MetroLinq have any failover or redundancy modes?
  18. What type of encryption does MetroLinq use for wireless links?
  19. What are the antenna beam-widths for the MetroLinq product line?
  20. Do I need the aiming scope for my MetroLinq?
  21. What is the Fresnel Zone for the 60 GHz MetroLinq radio?
  22. What SNMP versions are supported?
  23. What is the temperature range for MetroLinq radios?
  24. What is the maximum transmit power?
  25. Can I use the second GE port of the ML for traffic purposes?
  26. Can I use any ML device as a STA in a PTMP setup?
  27. What is the maximum cable distance between the PoE injector and the MetroLinq?
  28. Can I downgrade my MetroLinq devices to previous MetroLinq firmware versions?
  29. What separation distance I have to give to my MetroLinq radios installed on the same pole?

Feedback and Knowledge Base